CABLING · WI-FI · CCTV · GIPPSLAND
Keeping
the data moving.
Structured cabling, Wi-Fi coverage, CCTV networks, EFTPOS and POS lines for Gippsland venues and businesses. We pull the cable, terminate the ports, configure the gear, and leave the rack labelled and documented.
- ⚡ Wi-Fi heat-mapping
- ⚡ Cat6 / Cat6A cabling
- ⚡ CCTV + remote access
- ⚡ Documented rack work
THE WORK
What we get called for.
If the gear is plugged in and the data still isn't moving, the answer is almost always between the wall and the cabinet. We trace it properly.
Wi-Fi dead spots
Bad placement, wrong AP density, or interference. We heat-map the venue, identify where coverage actually drops out, and place APs to fix it — not just to add more.
EFTPOS / POS keeps disconnecting
Usually a flaky cable run, an overloaded switch port, or shared comms with too much chatter. We trace it properly with the tools and fix the cause, not the symptom.
Comms room that nobody can read
Spaghetti rack, no labels, no documentation. We cut the rack back, terminate cleanly, label every port, and leave you with a diagram.
Adding network points
New work area, new POS terminal, new TV with smart streaming — we run Cat6/Cat6A, terminate to a patch panel, and balance the network so the new gear doesn't degrade the old.
CCTV that nobody can actually use
Bad camera placement, low-spec NVR, no remote access. We design coverage that works, run shielded cable, and set up secure remote viewing for the manager.
New site or fitout
Greenfield comms — we design the rack layout, plan cable routes around mechanical and electrical, and install + commission ready for the fit-out crew to follow.
WHAT WE DO
Cable, configure, document, leave.
We don't drop the gear and run. We design the layout, run the cable, terminate to a patch panel, install + configure the switches and APs, test every port, and leave you with a diagram and labels that match. Future trades aren't guessing.
- → Cat6 / Cat6A structured cabling and patch panels
- → Wi-Fi heat-mapping, AP placement, coverage tuning
- → CCTV cabling, NVR setup, secure remote access
- → EFTPOS, POS and back-office network design
- → Switch and router installation + configuration
- → Comms-room cleanups and full documentation
- → Fibre patching and termination
- → Network performance testing and reporting
FAQ
Comms questions, answered.
Do you do residential as well as commercial? +
Can you configure the switches and APs, or just run the cable? +
How much does a network install cost? +
Do you handle data + electrical at the same time? +
What about ongoing support? +
BOOK A SITE WALK
Comms job to scope?
We'll come out, look at the room, the rack and the routing — then quote based on what we actually saw rather than guesses. No charge for the visit.